土压平衡矩形顶管施工引起的地表沉降规律研究

为了分析与掌握矩形顶管施工引起的地表沉降变形规律，提出基于MIDAS-GTS有限元软件的分析方法，首先，通过工程实例验证MIDAS-GTS有限元软件在分析顶管施工引起地表沉降变形的有效性；其次，通过影响因素的敏感性分析确定不同影响因素作用下的地表沉降变形特性，这些影响因素主要包括开挖面支护压力、侧摩阻力、地层结构特性等；最后，通过地表沉降变形特性分析得出矩形顶管的适用范围。研究结果表明:基于MIDAS-GTS有限元软件的地表沉降规律分析方法和结果，可为矩形顶管施工过程提供相关参考和借鉴。     

某基岩区工业固体废物填埋场地递进式场地环境调查实例

针对某基岩区简易封场后的固体废物填埋场,采用多层次、递进式调查策略,配合使用地球物理探测、直压式土壤快速取样、现场快速检测等技术,分3个阶段开展填埋场及其周边环境调查。第1阶段,调查地质环境特征,开展地球物理探测;第2阶段,调查填埋物、渗滤液主要组分及对周边积水、农田土壤、民用井水的污染情况;第3阶段,划定重点污染区域,开展土壤和地下水污染调查。调查结果显示,填埋区已发生明显渗漏,对邻近区域土壤、地下水及地表积水造成了一定污染,但未对周边农用地土壤、民用井水质等产生不利影响,总体处于可控范围。提出,通过削减污染源,切断污染物迁移、暴露途径,消除已有污染影响,长期跟踪监测等多项管控治理措施进行综合整治。     

基于ALOHA软件的某化工厂选址合理性评估

为了研究化工厂选址的合理性,以山东省某化工厂为例,采用ALOHA(有害大气空中定位软件)模拟软件定量确定厂区内环氧乙烷毒气扩散事故的影响区域和敏感点毒气浓度,结合GoogleEarth地图对影响范围进行实地拟合。结果表明化工厂的环氧乙烷储罐泄漏后,毒气扩散到厂区范围之外,毒气浓度在50~500ppm之间的重伤区(ERPG-2)扩散距离可达1.7km,对周围居民的人身安全构成严重威胁;厂区应根据拟合结果重新规划工厂中环氧乙烷储罐的位置;ALOHA软件对化工厂选址评价提供了新的手段。     

关于老工业区污染场地管理的探讨

根据在某老工业区第1批28块场地环境调查的实践,对污染场地管理中存在的问题进行了分析并提出了相应改进建议：①获取准确的场地资料难度很大,建议研究制定场地全过程档案管理制度;②工业企业关闭搬迁会产生新的环境污染风险,工业企业关闭搬迁应该成为污染场地管理的重要环节,环保部门应该在工业企业搬迁前介入,严格监管整个过程中的环境污染;③大量区域由于其中污染严重、风险高的场地缺乏修复资金而难以再开发利用,建议结合规划优先启动资金投入低的污染较轻区域修复,并同时对风险较高的污染场地进行风险管控,当区域开发取得一定规模、成就和收益后,可以整合资金力量和资源开展污染较重区域的修复。     

蒸发-固化法处理垃圾渗滤液反渗透浓缩液的研究

采用蒸发-固化工艺处理垃圾渗滤液反渗透浓缩液。蒸发工艺可将反渗透浓缩液减量化,固化工艺可将蒸发残留液中的污染物稳定化。研究表明,蒸发残留液宜采用水泥和石灰混合料进行固化,混合料最佳水泥与石灰质量比约为1︰2,每100 mL蒸发残留液(质量约为120 g)最佳投加量为50 g。固化体含水率低于40%,抗压强度高于1.0 MPa,适合填埋处置,其浸出液污染物含量较低。采用硅酸钠和硫酸钙作为添加剂可加快固化速度,提高固化体的抗压强度。利用蒸发-固化工艺处理反渗透浓缩液可取得良好的经济和社会效益。     

阜新市空气监测点位优化的聚类分析

基于聚类分析法利用数据之间距离系数进行分类的原理,建立空气监测点位聚类分析优化模型,结合阜新市地形、气象及历史监测数据,进行阜新市空气监测点位布设优化应用,优化结果表明:距离相似水平取d=0.3时,环保局(B点)与人民公园(C点)监测点空气污染物浓度分布相似性最高,合并为1点,增设气象台监测点位作为清洁背景点,4个点位构成阜新市空气监测新网络;利用CALPUFF模型模拟对优化后监测点位进行相关性检验。检验结果表明:监测点位优化后SO2浓度与实测值相关系数为0.984,PM10相关系数为0.968,NO2相关系数为0.973。CALPUFF模型模拟值与实际监测值之间相关系数均大于0.75,表明优化后的阜新市空气监测点位具有客观环境代表性;监测点位优化与检验方法具有一定应用价值。     

基于Matlab分析的台阶式场地平整方案优化设计

在某市餐厨垃圾处理厂场地平整设计中,利用Matlab软件对台阶式场地平整方案进行优化设计,即在Auto CAD环境下用等高线法计算各级台阶的土方量,用Matlab软件拟合出台阶设计高程和土方量的函数关系式,在约束条件下求解,得到了最优设计高程和基于土方挖填平衡条件下场地平整的最小土方工程量,为工程总平面布置提供优化方案。其分析设计方法可为工业企业台阶式场地的总平面布置设计提供借鉴。     

Taxonomic and functional variations in the microbial community during the upgrade process of a full-scale landfill leachate treatment plant – from conventional to partial nitrification-denitrification

• Upgrade process was investigated in a full-scale landfill leachate treatment plant. • The optimization of DO can technically achieve the shift from CND to PND process. • Nitrosomonas was mainly responsible for ammonium oxidation in PND system. • An obviously enrichment of Thauera was found in the PND process. • Enhanced metabolic potentials on organics was found during the process update. Because of the low access to biodegradable organic substances used for denitrification, the partial nitrification-denitrification process has been considered as a low-cost, sustainable alternative for landfill leachate treatment. In this study, the process upgrade from conventional to partial nitrification-denitrification was comprehensively investigated in a full-scale landfill leachate treatment plant (LLTP). The partial nitrification-denitrification system was successfully achieved through the optimizing dissolved oxygen and the external carbon source, with effluent nitrogen concentrations lower than 150 mg/L. Moreover, the upgrading process facilitated the enrichment of Nitrosomonas (abundance increased from 0.4% to 3.3%), which was also evidenced by increased abundance of amoA/B/C genes carried by Nitrosomonas. Although Nitrospira (accounting for 0.1%–0.6%) was found to stably exist in the reactor tank, considerable nitrite accumulation occurred in the reactor (reaching 98.8 mg/L), indicating high-efficiency of the partial nitrification process. Moreover, the abundance of Thauera, the dominant denitrifying bacteria responsible for nitrite reduction, gradually increased from 0.60% to 5.52% during the upgrade process. This process caused great changes in the microbial community, inducing continuous succession of heterotrophic bacteria accompanied by enhanced metabolic potentials toward organic substances. The results obtained in this study advanced our understanding of the operation of a partial nitrification-denitrification system and provided a technical case for the upgrade of currently existing full-scale LLTPs.     

我国污染场地土壤石油烃环境质量标准体系的现状与趋势

石油烃污染场地已经成为国内外重点关注的工业污染场地类型之一。国内基于人体健康风险的污染场地管理模式及分层次评估方法已经展现雏形,为风险管理者提供了基于人体健康的土壤石油烃风险筛选值和管制值,也为污染场地的防治与修复工作提供了决策支持。在前人研究的基础上,梳理了国内土壤环境质量标准体系的建立与发展历程,分析了石油烃类污染物检测方法的现状与未来发展趋势,并着重对比与分析了各标准制订的石油烃及其指示化合物的风险评估筛选值。目前面临的关键问题:①完善石油烃监测指标体系及分析方法是精准获得风险评估结果的前提。现有石油烃馏分指标划分较为宽泛,有必要参考国外先进标准体系,逐渐完善石油烃馏分指标划分及其配套的定量分析方法。②新颁布的国家建设用地土壤污染风险管控标准在前期场地调查中具有一定的普遍适用性,但是考虑到地域建筑物参数、人群暴露参数等的差异性,在后期场地调查中还需要因地制宜地制定适合污染场地的具体修复目标值,并针对关键性参数作定量化解析。     

Optimization-Based Atmospheric Plume Source Identification

This work applies optimization and an Eulerian inversion approach presented by Bagtzoglou and Baun in 2005 in order to reconstruct contaminant plume time histories and to identify the likely source of atmospheric contamination using data from a real test site for the first time. Present-day distribution of an atmospheric contaminant plume as well as data points reflecting the plume history allow the reconstruction and provide the plume velocity, distribution, and probable source. The method was tested to a hypothetical case and with data from the Forest Atmosphere Transfer and Storage (FACTS) experiment in the Duke experimental forest site. In the scenarios presented herein, as well as in numerous cases tested for verification purposes, the model conserved mass, successfully located the peak of the plume, and managed to capture the motion of the plume well but underestimated the contaminant peak.